Forum Replies Created

Page 55 of 699
  • Bret Williams

    June 21, 2016 at 1:32 am in reply to: Misplaced clips after rendering

    Are you talking about FCP 7 and h264 media? Sure sounds like it.

  • Bret Williams

    June 14, 2016 at 3:24 pm in reply to: Frequent crashes

    I’ve tried them and they crash my system just as bad as the current ones. For me, the changing factor was El Capitan. Doesn’t matter what drivers. So I went out and bought an AJA. All fixed.

  • Backups are made every 15 minutes. How are you accessing the backup?

  • I believe that was February, right? Seems to me from Feb to June that’s all we talked about. It was known that Larry and others had been to a special closed presentation on the next version of FCP.

  • Quick trick if you don’t want to muck it up with compounds…

    Blade the logo (or clip). If you want a 30 frame transition, blade the clip 15 frames in. Drop the transparency to 0 of the left portion (or right portion if it’s an outgoing transition) and apply the transition to the bladed spot. The transition will stop affecting the video below it because it now has a (transparent) source to affect.

  • Bret Williams

    May 26, 2016 at 2:00 pm in reply to: multicam click at each cut

    Audio pops on audio edits have been a staple of NLEs for over 20 years. Don’t mess with tradition!

  • Bret Williams

    May 25, 2016 at 7:10 pm in reply to: multicam click at each cut

    Here’s a screenshot of a multicam. See how the highlighted clip’s audio goes underneath multiple clips. The clips it goes under don’t have any audio (it’s turned off in inspector). I tend to do this for each speaker/audio source once the image is locked, and before audio mix because it’s easier to adjust one level than a bunch. Also easier if you’ve added compression or eq. As well, as you can see, often I’ll overlap and do a fade between the speakers.

  • Bret Williams

    May 25, 2016 at 6:54 pm in reply to: multicam click at each cut

    Audio is always cut along with the video. Sometimes resulting in an audio pop. So take the fist clips audio an drag it out under all the video cuts like a big L cut. Make sense?

  • Bret Williams

    May 25, 2016 at 6:14 pm in reply to: multicam click at each cut

    I like to expand audio components on the first cut and drag out the audio track the length of the multicam portion. Then turn off audio in all the other cuts. So it’s similar to breaking apart audio to get an unbroken audio track, but without breaking sync. You may want to group them in a secondary timeline as well to keep the clips synced together.

  • Bret Williams

    May 24, 2016 at 2:13 pm in reply to: BMD driver 10.6.5 – still useless

    Never mind. F* me. Crashing out to decklink CMIO again. (plugs back in AJA)

Page 55 of 699

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy