Brad Froman
Forum Replies Created
-
Sorry…I meant to say I chose Easy Setup for “AJA Io – NTSC US Betacam 10 Bit Uncompressed. The timeline setting is 29.97. So, again, after creating a new Project, I digitize a sample clip (which looks and sounds fine importing through AJA), when I try to play the clip back, the AJA does not allow me to see/hear the clip.
Audio/Video settings are as follows:
Sequence Preset: Uncompressed 10-bit NTSC 48 kHz
Capture Preset: AJA Io: YPbPr Betacam 10-bit NTSC US 48 kHz
Device Control: AJA Io RS-422 NTSC
Video Playback: ProIo – NTSC US – Component YPbPr Betacam 525 – 10-bit (720×486)
Audio Playback: ProIo Out -
Wow…there you have it. A good first step for me to come here. Had no idea about Promax. Thanks…and I will be doing my research in here.
-
Great information. Thanks so much for taking the time to help me.
-
It would be for .wmv, Quicktimes, .mp3, mpeg1, 2 and 4, iPod,…mostly the popular ones. Thanks.
-
I mixed down the audio and saved it to the 1.25T ProMax RAID drives. Didn’t make any difference.
The 1400 is set for 1394 in. I’m not using any firewire storage…and nothing else firewire, for that matter.
I’m beginning to wonder, since I have FCP 4.5…and the 1400 deck just came out, that maybe my older version of FCP doesn’t understand fully how to talk to the deck. But, I would find that hard to believe since I had no problem digitizing the footage and audio from the deck.
Thanks for the help, Gary.
-
Great. I will certainly give that a try…but 1st thing in the morning. I’ll let you know what happens. Thanks, David.
-
I had already turned off the “dropped frame” warnings…but the audio dropped out at the same point (goes for 6 seconds…then out). I can cue up anywhere on the timeline…and it will the audio stops 6 seconds later. It’s as if the buffer fills up.
It’s quite a puzzle to me. Thanks for trying to help, David.
-
There is no other firewire device hooked up. The SATA drive is only 30% full. It is an edited timeline I’m outputting.
And by the way, The exact same problem occurs whether it’s this 1080i sequence, or a different 720p sequence. Audio plays back fine for only 6 seconds…then “dropped frames” and freeze. Video plays perfectly.
I’ve tried different sound files to see if it could have a corrupted track…but the exact same thing happens.
Picture and sound digitized into FCP through the same deck and same firewire cables/ports…just as clean as a whistle.
-
It’s one single wave file. And yes, deck is set to 1394. Is there a menu item?
-
Oh…meant to say…when audio playback is set to DVCPRO, it the audio actually goes out to the deck for about 3 seconds…then there is the “dropped frames” issue. But i can start the sequence from that point…and play out again for about 3 seconds then freezes up again. The audio file is fine. Everything is rendered.