Replies – Forums – Vihang Walve

Forum Replies Created

Vihang Walve
January 23, 2012 at 9:19 pm in reply to: how to transfer 3/4″ tapes from Sony VP 7020 Umatic on Final Cut?

Thanks Neil
I have a AJA lo express but I dont know how exactly that should be attached to the Umatic?

vihang
Vihang Walve
January 20, 2012 at 12:08 am in reply to: How to transffer Digibeta to FCP via AJA express

Also.. I tried firewire too. but its showing the same message.. unable to initialize.. so am I making some mistake in input or output format??

vihang
Vihang Walve
January 20, 2012 at 12:05 am in reply to: How to transffer Digibeta to FCP via AJA express

Well explained.. thanks a lot..
I ll get the cable now… Just want to confirm that this is not a software or format issue..
thanks a lot for ur help..

vihang
Vihang Walve
January 19, 2012 at 11:58 pm in reply to: How to transffer Digibeta to FCP via AJA express

That was helpful Shane… this is the first time m operating this.. so its little complicated for me..
so where can i find the Uncontrolled device option.. its certainly not on the deck..

vihang
Vihang Walve
January 19, 2012 at 11:55 pm in reply to: How to transffer Digibeta to FCP via AJA express

That was helpful Shane… this is the first time m operating this.. so its little complicated for me..
so where can i find the Uncontrolled device option.. its certainly not on the deck..I ll try to get the RS-422 cable.. but I need to transfer few tapes today ASAP..:(
Is there any way I can make it work?

vihang
Vihang Walve
January 19, 2012 at 11:45 pm in reply to: How to transffer Digibeta to FCP via AJA express

If I am mistaken are you talking about external control setup?
i didnt do anything externally.. i tried changing formats in easy setups.. sometime it shows unable to initialize video.. does it mean the video is detected and there could be a software issue??
I tried installing latest version of Quick time too and used firewire directly to the machine also… nothings working for me..

vihang
Vihang Walve
January 19, 2012 at 11:32 pm in reply to: How to transffer Digibeta to FCP via AJA express

I have a single SDI pin that goes from deck’s SDI output to AJA SDI input..wont it work??

vihang
Vihang Walve
January 19, 2012 at 11:19 pm in reply to: How to transffer Digibeta to FCP via AJA express

here is the config

deck- sony J30SDI
AJA kona version – lo express
SDI in – 525i29.97
SDI out – 1080sf 23.98

vihang