Vasyl Iskovych
5
AE Expressions Coins
34
After Effects Coins
39
COW Coins
1
Solve Coin
Forum Replies Created
-
I think the problem was that you were adding the Turbulent Displace effect to a 3D layer that had Preserve Underlying Transparency turned on.
In this combination, you needed to turn off the “Turbulent Displace” effect, or one of the “3D Layer”, “preserve underlying transparency” switches.
If you could make and send me a simple example of a project (not necessarily the original), I would show you better.
-
Can you send me a draft of the project that shows the problem?
That way, I can tell you how to solve it.
-
Try deleting or disabling the “Turbulent Displace” effect (you can add the “Wiggle Paths” animator for the gray shape instead).
Enable 3D for all layers and turn on “Collapse Transformations” for the pre-comp.
If this does not work, please send a draft of the project where we can see the problem.
-
Maybe it’s not quite right, but can you try to duplicate the placeholder and make the effect for each side?
Please see the attached files.
-
I think you used the Roto brash tool when the playhead was in the first frame.
By doing so, you created a keyframe at the beginning, and this does not allow you to change the beginning.
Switch to the right frame before using the tool.
Then you can change the beginning.
-
Hi there.
Perhaps you could achieve something similar with effects?
-
Thank you very much for your help.
I spent several hours searching for this information on the Internet, but I didn’t find anything.
Thank you very much.
-
OK.
I understood.
I just saw binary code in several other projects that I was looking at and wanted to do the same.
Its use is not a necessity.
Thank you again. -
Thank.
I really appreciate your help.
I would like to ask one more question.
Before sending the project to VH, I planned using a script to translate all the expressions into binary code.
For example:
eval (“@ JSXBIN @ ES @ 2.0 @ MyBbyBn0ABJAnAARCFdjYFd2kQBf0DzABByB”)
But such expressions only work if Legacy ExtendScript is installed in the project settings.
And your Anchor Point expression only works if JavaScript is installed.
Is there any way to fix this?
And a good or bad idea, with the conversion of expressions to binary code? -
I am very grateful to you for your help.
Unfortunately, I still did not understand how these expressions work, but they work exactly the way I wanted.
Can I thank you somehow?
Maybe I can somehow pay you for your work?
I will not be able to send a large amount.
But I can offer $ 20- $ 30;
(Please don’t laugh if this is too little for you)
