Replies – Forums – Russel Fong

Forum Replies Created

Russel Fong
October 24, 2011 at 3:12 pm in reply to: New Quicktime Player Crops your Videos on Playback!!

Hello –

If my converted footage from Compressor accidentally had the the tab checked, is there any way to still export full 1920×1080 from FCP without the letterbox?

Russel
Russel Fong
April 14, 2010 at 7:22 pm in reply to: Canon 5D Monitor Playback

Hey Robbie,

After more tweaking, I set the KONA at 1080i29.97 and it played on my SHARP LCD. Didn’t think of it earlier because my quicktimes are 23.98, but whatever works.

Thanks,
Russel
Russel Fong
April 9, 2010 at 7:36 pm in reply to: Batch add Timecode track to lots of files (5D)

Hey Rodrigo,

So, I was able to take the H.264 1920×1080 clip and convert it to a ProRes clip. I was then able to have QTChange find it. I was able to alter the timecode, but when I bring it into FCP, the audio is slightly off. Not by much, but maybe a frame or two. Have you used QTChange enough times to give me your thoughts on that? I didn’t mess with anything else in QTChange.

Thanks,
Russel
Russel Fong
April 7, 2010 at 12:53 am in reply to: Batch add Timecode track to lots of files (5D)

Thank you – I will give it a try when I get the first round of footage tomorrow!
Russel Fong
April 6, 2010 at 9:04 pm in reply to: Batch add Timecode track to lots of files (5D)

Hi Sam,

I had a question about your last post. I am editing with 5D footage for the first time and will be receiving it soon. I know there is no timecode within their files, so I looked into DPX, Glue Tools, putting the 5D’s footage to tape, etc. It does sound like transcoding through Compressor (or can FCP assign TC?) is the best bet. Depending on how much footage I receive, will it assign timecode continuously? Or will each clip start at 00:00:00:00, depending on how many clips are given to me? Any more insight will help. Thanks!

Russel