Rohit Gupta
Forum Replies Created
-
Could you please give details on which motherboard you are using, which CPU, how much RAM, and which slots have which cards?
Some of the motherboards like the X79 chipset only support x16 speeds in a certain PCI-E configuration. When you start adding more cards, the bus drops to x8, etc.
-
The load on the GUI card, and bus speed is significantly more when you are using video monitoring. I suspect your GUI card is not running at full x16 speed, and this is causing the issue.
-
What is your GUI GPU and what slot speed is it running at? It needs to be Q600/Q4000 or better, and needs to be in a x16 PCI-E 2.0 slot.
-
You need a minimum of 1680×1050 resolution to run Resolve.
Regards,
Rohit -
Hi Michael,
Is it possible for you to upload and then send the link to this clip to us at davincihelp (at) blackmagic-design.com?
We’ll check this out.
Regards,
Rohit -
There’s a setting in the Decklink Control Panel to “Remove jitter when paused”. Try switching it off.
-
Can you please grab logs when you get the crash, and send it to davincihelp (at) blackmagic-design.com?
/Library/Application Support/Blackmagic Design/DaVinci Resolve/CaptureLogs.app
Regards,
Rohit -
There is an option to add additional media if you right-click on the XML timeline. You can use this to point to other volumes where rest of your media is.
-
The GUI viewer displays full-range RGB data.
If you are video monitoring is set to display normal scaled video, then the full-range data gets scaled to video range data on the Decklink video output.
Regards,
Rohit -
Hi,
A few questions:
1. What resolution Epic files are you using?
2. What decode mode are you using – Half Res Prem/Half Res Good?
3. What Rocket Firmware are you using?Regards,
Rohit