Rodolfo Guedes
Forum Replies Created
-
Nope. This was my only project where i needed it, but, as time run out, i had to go manual. The sound i used was from the cams mic, so that might have confused Resolve…
-
Thank you. Already seen this tutorial. But, Davinci couldnt sync the clips to the audio track. Thats why i had to sync them manually. Isnt there any way to put each video track as an “angle”, in a multicam timeline?
-
Of course, how could i forget about the cloner. Thank you, sorry for not thinking of that right away, it was so obvious..:)
-
I’m sorry.. I’ve talked before i’ve tried.. It works perfectly. I just had to extrude the spline and it fited.. Thank you so much
-
That’s almost what i’m looking for, but instead of a spline,i’m trying to put an extrusion.. Picture a pin with some text beveled..
-
I wanted to bend the extrusion so that it followed the curvature of the spherical part of the oil tank, the top.
The idea is to use the oil tank primitve with a little height so that it looks like a pin. Then, the extrusion would stick out in a way that its height would the same all over the top of the pin, following the curvature that the pin has..
It may sound a bit complex, but its really simple..
I’ve tried the wrap object, but it’s too complicated to get the exact curvature, i’ve tried the spline the spline wrap, but i can’t make the curvature for both x and y axis.