Forum Replies Created

  • Rob Brunner

    April 5, 2009 at 5:44 pm in reply to: Problem with Kona 3 – new installation

    Worked perfectly! I am up and running. Thank you so much.

    Rob Brunner

  • Rob Brunner

    April 4, 2009 at 11:32 pm in reply to: Problem with Kona 3 – new installation

    Hey Guys. I was just reading your thread and i have a similar problem.
    I just updated my tower to Leparod and my final cut would load up and just crash before getting past the load screen. So i deleted my prefrences and got a little bit further.
    As soon as i tried to load a setup that involved my AJA Kona card it would crash again.

    I then tried to get into my AJA Kona Control panel and it would also crash.

    So i just tried to get to my Expansion Slot Utility app. and there is a big circle with a line through it saying that it is not supported on this architecture.

    What can i do to get up and editing again???

    Thanks in advance

    Rob

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy