Replies – Forums – Paul Watson

Forum Replies Created

Paul Watson
October 21, 2013 at 9:14 pm in reply to: Stop first clip on timeline overriding project settings

Is there any way to change the frame rate after the timeline has been set? I have a project where the footage is 29.97 and somehow the timeline got set at 23.98. This has caused all kinds of problems. Especially when put on our server. The video runs at 29.97 not 23.98, causing the video to run faster than the audio so sound sync disappears almost immediately and never returns. Plus the video runs out before the sound so the audio ends up playing over black as the server waits for the audio to finish. Not pleasant to watch!
I haven’t been able to find anyway to reset the frame rate in either the timeline or event.
Paul Watson
April 28, 2005 at 3:04 pm in reply to: Capture now problem

I checked and the “limit capture now” was checked and checked the “limit capture and export…” to the default and still have the same problem.
Paul Watson
April 25, 2005 at 8:05 pm in reply to: batch capture timecode problem

If you have varying timecodes on your tapes, that is where you have quite different time codes on different clips, that can be a problem too. What I do is to pre-stripe all my new tapes with original timecode and then use the regenerate timecode from the camera’s recording setup menu. That way there is never a timecode break on a tape.
Paul Watson
April 25, 2005 at 7:44 pm in reply to: Capture now problem

What should the limit be set to?