Replies – Forums – Odysseus Ming

Forum Replies Created

Odysseus Ming
September 13, 2007 at 4:53 pm in reply to: mackie 1202 setup

Walter – that did it. Thanks.
Odysseus Ming
September 13, 2007 at 4:32 pm in reply to: mackie 1202 setup

I am coming in through the 1/4″ plugs in lines 1+2 (sorry, that’s my mistake I didn’t make it clearer – I have XLR to 1/4″ cables coming from Behringer to Mackie).

Should something be selected in the “CONTROL ROOM SOURCE” box over by the meters?
Odysseus Ming
September 13, 2007 at 4:17 pm in reply to: mackie 1202 setup

I’ve got to be doing something wrong then, because if I don’t have the PRE-FADER SOLO buttons selected, I can’t hear anything. No levels in the meter, and no sound…I’ve read the whole manual and can’t seem to figure it out.
Odysseus Ming
September 13, 2007 at 3:39 pm in reply to: mackie 1202 setup

Alright, thanks Walter. And one more question on configuring this thing:

I have the gain knobs for LINE INs 1+2 set to 0. Then I have the PRE FADER SOLO buttons selected for LINE INs 1+2, but the level meter is only lighting up on the right side? Is this the correct configuration?

Thanks.