Mkranyak
Forum Replies Created
-
No, my sequence is set to DV/DVCPRO – NTSC. I’m using FCP 4 HD version. I’m loading from beta, converting the signal to DV, the firewire to my computer……. I see the drawdown menu for SEQUENCE SETTINGS and see 10 bit but it’s uncompressed….. mine is not….. so if i understand properly, the only way to get “smooth” is editing uncompressed or HD ?…. makes sense……..thanks..mk
-
I’m capturing beta from a ampex CVR-70 betacamSP deck sending the composite out signal to my JVC mini-dv deck then firewire from the JVC to my G4. I will redigitize and be more diligent on setting my levels to see if problem is an actual problem. I guess what perplexes me is even if my levels were not set properly, why should i see any difference between viewing during digitize versus playback… just thought maybe someone else had seen this before………but as i usually find in the end, the solution is go back to basics, “read the instructions” and practice proper editing techniques…. again, it’s not a debilitating problem and i’ll probably solve it by following my previous advice…..later..mike
-
Will check levels on digitizing again, but this has been happening lots of times… again, if it looks good on the monitor when i digitize, i would think it would look good on that same monitor when i play back the digitized footage….but will be more diligent on levels when digitizing… perhaps just load it in a tad lower level and that may compensate for the problem…. thanks for the info…mike