Forum Replies Created

  • Mike W

    November 10, 2005 at 1:10 am in reply to: 10bit won’t edit to tape

    Thanks David & Gary for your time & responses. There are definetly some quirks that pop up now & then. I’ve been able to figure most of them out until now. The posts here on the cow are very valuable. However, this is an odd one. Most indications are pointing to the SCSI card and or the lack of having a Tiger in the tank.

    Thanks again,

    Mike

  • Mike W

    November 9, 2005 at 3:10 am in reply to: 10bit won’t edit to tape

    Gary–
    Thanks for the response … my bad the quicktime is 7.0.1. Hard to tell from the posts if 5.03 is okay to use. Obviously it is, from your response, but with 10.4.2 & QT 7.03 What about 10.3.9? No audio to mix down, everything was rendered & no open scopes. Source was actully rendered in After Effects with the 10bit Uncompressed codec imported into FCP. Same workflow as a previously working FCP 4.5, nothing has changed other than the switch to FCP 5 & QT. Trying to put off the jump to 10.4.2 for a liitle while … it may be sooner rather than later.

    Thanks again,

    Mike Watson
    High Noon Entertainment
    G5 Dual 2.5 4GB RAM
    OSX 10.3.9
    Kona 2 Ver. 1.1.4
    HUGE U320RX 2.5TB, 0 Raid
    Atto UL4D

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy