Mike Kahn
Forum Replies Created
-
nevermind, there was a duplicate up/down that said go to next page in the timeline panel
-
Thanks for your input Scott.
-
So if you had to deliver a two minute spot, your out point would be 1:59;58 or 1:59;59?
-
I appreciate the response Scott. It makes no sense that an editor would skip valid timecodes because they’re odd numbers. I’ve tried in both FCP and premiere and both put the in point on hh:00:00;00 and the out at hh:01:59;29. The next clip would begin at hh:02:00;02. This is just accepted as how avid does df timecode?
-
Try to delete your render queue and thumbnail cache. Sometimes they can get corrupted and show green screens.
-
-
This is for the application, not project based. And I was a bit off, 32bit applications can use about 3.5gig of ram, not 2 gig.
-
Sounds like you need to change the deck frame rate back to 29.97. I think FCP is telling the remote to look for one frame rate and the deck is giving a different one.
-
This is what I use and a lot of other facilities:
https://www.bluemic.com/snowball/ -
Mikaela is the editor having the issue, I sent the first post for her.