[Maria-luisa Meredith]

I have since realised that the first part of the tape has clip properties as follows:

2 mono/48khz/16 bit integer/720×576/PAL CCIR 601

but after a timecode break on the tape (although the entire tape captured as one clip) the clip properties are:

1 stereo/48khz/32 bit floating point/768×576/Square

I’m not quite sure at what point in the process or how this has happened. Does any one have experience of this? Thanks.

Maria

[Maria-luisa Meredith]

Hi
Thanks for the reply, and no the FW port wasn’t working with anything. Problem solved though: I repaired permissions and that seems to have done the trick. Cheers.
Maria

[Maria-luisa Meredith]

Hi Jeremy
That does seem to have been the problem, thanks for the tip.
Maria

[Maria-luisa Meredith]

Thank you for that Rafalaos, I will try your suggestions.
Maria

[Maria-luisa Meredith]

Thanks for that.
Maria

[Maria-luisa Meredith]

Thanks, a great and varied response. I’ll see what works best.
Maria

[Maria-luisa Meredith]

Thanks, I have had a few techniques sent through. I guess I’ll see what works best.
Maria

[Maria-luisa Meredith]

Thanks, I’ll give that a try too.
Maria

[Maria-luisa Meredith]

Thanks, I’ll give that a try too.
Maria

[Maria-luisa Meredith]

That’s great Todd, I’ll try that now. Thanks so much
Maria