Marco
Forum Replies Created
-
ok are you taking about changing rge relative scale of the noise shader in the transparency material? i tred changing the uvw mapping under projection and change the length but that didnt do anything. so i went into the trasparency and started moving the scale and that show some potential.. is that what you were taking about or is there a easier way..
thanks by the way for anwsering me -
Mylenium
hey im sorry to be a idiot. but can you show me how to do that..
thanks -
I want the logo not to be flat when I look down, and ech to be balloony but I want the back to be flat. Thank You So much for that and I will start looking.
-
Oops I forgot the website
its http://www.sva.edu
its the school of visual arts logo -
Adam,
I want to give you a better understanding on what I want to do. Go to this website and check out the logo. That is supposed to be a flower. What I want to do it have a sphere, then have this logo right on the sphere, but the empty space on the logo is not there. Its cut out so you have this logo in a sphere shape on the front and the back. The reason I want to do this is I want to create a spinning move on this logo, so I need to see the back and sides. -
ok I tried that. I get the front to be round. but the back isn’t the same. I want it round just like the front. What I did before was I took the logo and used spline acroos geomotry (Radical) and I that worked and Iextruded that to a sphere then usen boole and that worked but the front and back wasn’t connected. Also when I made it round the surface has all these lines on it, its not smooth. Any ideas on hoe to fix that?
-
i tried that but the look I want is pretty much a round ball with the logo on it. so when you look at the top of the logo its looks like a ball also. the logo is round and its 1 piece.