Replies – Forums – Lewis Long

Forum Replies Created

Lewis Long
September 1, 2008 at 3:35 am in reply to: Export on DVD in Widescreen format

Never mind that last suggestion wouldn’t work…because I’m not actually capturing the video….crap…
Lewis Long
September 1, 2008 at 3:21 am in reply to: Export on DVD in Widescreen format

Would it work if I 1) export the entire movie…. 2) then bring that quicktime file into a new anamorphic sequence in FCP and 3)export that sequence into a new quicktime file….
Lewis Long
September 1, 2008 at 3:11 am in reply to: Export on DVD in Widescreen format

I checked the settings and I did not set the capture settings to anamorphic…damn…so I guess that I’m stuck with what I have. Any other ideas..or would I basically have to recapture everthing again.
Lewis Long
September 1, 2008 at 2:32 am in reply to: Export on DVD in Widescreen format

Yes I do see the bars in the quicktime file…How do I go back and change the settings
Lewis Long
July 20, 2008 at 8:10 pm in reply to: How to eliminate microphone bumps

Let me clarify what I meant…The person holding the boom mic, was also holding the boom mic cord..And when he would adjust his hands, the cord would make that bumping noise. Any other suggestions…
Lewis Long
April 11, 2008 at 6:02 pm in reply to: Final Cut Pro will not let me to render a QuickTime file because of required Compressor

But I can’t export it becuase my quicktime won’t even read the file,and when I try to put it into the timeline FCP will not render it. Is it possible to Export a file even if you can’t open it?
Lewis Long
April 11, 2008 at 5:43 pm in reply to: Final Cut Pro will not let me to render a QuickTime file because of required Compressor

I think that I found out the problem, I believe that my FCP HD version is a little behind. The quicktime file was saved with a H.264 codec, and my FCP HD doesn’t support that codec (it supports H.293). So, I believe the file will have to be re-exported in animation, etc.. so that I can open it. If that’s not the case, then are there any other options.
Lewis Long
April 11, 2008 at 5:09 pm in reply to: Final Cut Pro will not let me to render a QuickTime file because of required Compressor

Ok, where does it tell you what codec. I see where it says QuickTime Video settings..and it’s set at DV/DVCPRO-NTSC..And as far as the quicktime video, FCP won’t even allow me to open it up without giving me the error of “I need the required compressor”
Lewis Long
April 11, 2008 at 4:44 pm in reply to: Final Cut Pro will not let me to render a QuickTime file because of required Compressor

How do I find out what the codecs are