Replies – Forums – Kyle Ussery

Forum Replies Created

Kyle Ussery
October 10, 2020 at 11:55 pm in reply to: Script to trim end point of layer when opacity is at 0%.

Thanks Filip, I’ll check this out. I usually always gain some new knowledge from scripts, even if the scenario isn’t exactly right.
Kyle Ussery
October 1, 2020 at 1:32 am in reply to: Script for setting inPoint and outPoint of images using .csv

Thanks Stephen,

That’s a good idea too. I’m much more versed in expressions than scripts, just wasn’t sure how to approach it. But that sounds like a good direction.
Kyle Ussery
September 30, 2020 at 1:26 pm in reply to: Script for setting inPoint and outPoint of images using .csv

Thanks Thomas! These are all great pieces of info to think about.

1. I’ll put all the images in a folder in the project.

2. The images will be 1920×1080 inside of a 1920×1080 comp.

3. Correct, no animation on images, just static, one ends and another starts.

4. I can definitely clean up the naming convention.

How should I get this script started?