[Ken Roberts]

Thanks for that – but honestly I can’t follow it at all.
With earlier versions the method was just select all clips as a block, then drag to right and Drop. DONE.

Your first part says, “basically you have all the clips you would have as a single (virtual) clip in one sequence.
”

???? As an analogy, if you asked me how to

That’s the problem – I do not know how to to that? Can you give me the steps?

Your next sentence says, “Then you would make a new sequence and add the first (virtual) sequence into the new one.”

Not only do I not know how to do that – but I must ask you . . . . . . . assuming I knew how to accomplish that . . . then why would I “add that first Virual sequence into a new one”. I do not know HOW to make the “First Virtual Sequence”.

I appreciate the Help but I just can not follow the response. I was hoping for a step-by-step . . . “select that Tool which is located “here” and then drag to select all clips, and then drag them to “there” which is locatred to the right of “this” . . .etc . . . etc

Sort of a more basic How-To if possible.