Replies – Forums – Justin Sandercoe

Forum Replies Created

Justin Sandercoe
February 11, 2010 at 10:04 pm in reply to: Final Cut Pro and JVC GY-HM100 problems. Help needed.

Hi Kylee

Not tried removing FCE 4 yet – I didn’t think they would conflict being different programs.

Is there a good chance that there could be a conflict between them? Seems a lot of work but I would give it a go if there was a good chance that that is the problem…

Appreciate your advice, J
Justin Sandercoe
February 11, 2010 at 4:14 pm in reply to: Final Cut Pro and JVC GY-HM100 problems. Help needed.

Thanks Rafael

So the red Not Responding may not be a proper hang. I had noticed that these was still activity in disk and the amount of threads and memory was changing…

Could the plug in be effecting the compressor? I can get the files into FCP and edit fine, the export seems to be the problem!
Justin Sandercoe
February 11, 2010 at 3:58 pm in reply to: Final Cut Pro and JVC GY-HM100 problems. Help needed.

Thanks for the response.

Yes I repaired permissions for the sys drive. I got some messages I had not seen before, can’t recall exact wording but close to:

WARNING: SUID Files were modified and not repaired.
usr/bin/rsh
usr/bin/rlogin
usr/bin/quota
usr/sbin/pppd
usr/sbin/uprid

I have FCE 4 on my system. I purchased a full FCP7 and installed it on the same drive. It was not an upgrade.

The media is going from the HDSC card onto a Lacie Quadra 500Gb 7200rpm external drive which is connected by eSata (going into a eSata PCI card).

The computer is in my recording studio and installed are audio applications, Pro Tools HD, Logic, which both seem uneffected by all this other polava.

Thanks, J