Jason Levy
Forum Replies Created
-
Yes. Still off.
j
-
I know I know… Mea culpa. But I’m sure 90 % of y’all are running that combination of updates. Why me??
Exports come out fine. Anything that stays in mac os is fine. Any time video comes out through the Kona its off. Export a quicktime and the quicktime is fine.. in mac os. Try to lay it back to tape or play it on the Panasonic broadcast monitor via Kona and it’s off.
j.
-
Interesting.. That made it worse. There is something fishy in Denmark.
j
-
Thanks Dan will give that a try in the morning.. Not sure why it would suddenly break like that. ‘preciate the help.
jason
-
Yeah we had one like that when I was a kid. When it went all screwy you just gave it a good whack on the side. Very analog.
-
Is there a menu setting on that deck telling it where to get the sync signal? Can’t remember.
-
Thanks Jeremy. No not dropping frames, warning is on. Media is on a raid5 SAS drive tower (proavivo 8 drives) hooked up to a ATTO r380. Atto utility reports everything is fine. But I also have a JBOD sata raid 0 array and shows on that drive also play back funny. Everything plays back funny no matter what drive it is on. And as I mentioned it was all working correctly a couple of weeks ago. Same media, same 10 episodes on the SAS, same 3 documentaries on the JBOD Everything fine then, everything has a lag now.
Only thing I did was update OSX and FCP and update theKONA driver. Have now gone back to the old driver but still have the problem. Should have cloned the drive first… learned my lesson.
jason
-
Yes first thing I thought of because I had heard of that problem and checked the slots and the slot utility settings. and then went over the whole thing again with the support guy from AJA… The card is in the right slot and the speed is set correctly. It does sound so much like that problem but I don’t know what else to look at. I wonder if it’s some kind of hardware failure either in the Mac or the Kona.
thanks Bob.
Jason
-
Yes, 59.94. Also having the problem on 23.98 timelines. Having the problem on any timeline, including stuff that was working fine before and has not been altered.. so I’m assuming it’s not the sequence settings.
Thanks…
j.
-
I appreciate any suggestions as I’m stumped.. All this is prores 720 footage.. it has been working fine for months.. same shows that played back fine before are off now.
Thanks for the info, it’s appreciated.