Replies – Forums – Hugh Denholm

Forum Replies Created

Hugh Denholm
April 19, 2009 at 12:46 pm in reply to: Importing AVCHD Lite into FCE

Hi Tom
Just realised that the book I am using to learn FCE is FCE Editing Workshop, by you! Excellent book!
Hugh Denholm
April 19, 2009 at 6:23 am in reply to: Importing AVCHD Lite into FCE

Yes Tom, as you previously suggested on this thread, I am using HDV AIC 720p25.

Will just have to wait for an FCE upgrade. Thanks for your help.
Hugh
Hugh Denholm
April 19, 2009 at 2:54 am in reply to: Importing AVCHD Lite into FCE

Hi Tom
The only camera settings I could find to quote where “AVCHD Lite at 1280×720, 50P/17Mbps at 25fps” as per previous post. Not sure what you mean about FCE settings.

Maybe FCE does not support AVCHD Lite yet….
Hugh Denholm
April 18, 2009 at 6:05 am in reply to: Importing AVCHD Lite into FCE

Yes Tom, that seemed the most applicable codec.

Do you know if others are successfully importing AVCHD Lite to FCE?
Hugh Denholm
April 18, 2009 at 1:32 am in reply to: Importing AVCHD Lite into FCE

Hi Tom
Thanks for your response and sorry for the incomplete information.
Camera is Panasonic FT1 capturing AVCHD Lite at 1280×720, 50P/17Mbps at 25fps. Results are the same if I capture out of the camera or with the card in a reader.
Computer is a 2.8 8 core Mac Pro (2008) running 10.5.6
FCE is version 4.0.1
FCE site on boot drive. Clips sit on a separate 1 TB data drive installed in the computer.

When I add clips to the queue, the status wheel will turn for about 5 seconds and stop. If I then click on the status wheel it turns to a red exclamation mark and a right click reveals a message saying “no data”.
The preview on the right hand side of L&T works fine.
I have tried changing to plain stereo and clearing the cache, no luck.
Thanks again for any help.
Regards
Hugh