Replies – Forums – Enginn Heima – Page 3

Forum Replies Created

Page 3 of 10

← 1 2 3 4 … 10 →

Enginn Heima
March 26, 2019 at 2:24 pm in reply to: seconds and not frames
Enginn Heima
March 25, 2019 at 3:56 pm in reply to: where is Solid Color inside Color?

Thank you for these clarifications!
Enginn Heima
March 25, 2019 at 9:53 am in reply to: image sequence nightmare

Thank you both of you for your inputs!
Enginn Heima
February 11, 2019 at 4:51 pm in reply to: Monitor calibration

I tried switching the Color management to “Resolve YRGB” instead of “Color managed” but that did not change anything. I then tried to run DisplayCal again and created my 3D LUT once more, but neither did that change anything.

Anyone? Any more ideas!?

And just a simple question, why are my clips showing up decently in the Media Pool tab and not in the EDIT and COLOR tabs? Is this normal that it shows up differently in Media Pool?
Enginn Heima
February 9, 2019 at 7:37 pm in reply to: Monitor calibration

Thanks, I will try to generate a new LUT and see if I get any luckier ☺

But can you tell me, why does the clip look when previewed in media pool and not in edit nor in color my de? Is this normal?
Enginn Heima
February 8, 2019 at 6:04 pm in reply to: Monitor calibration

Thank you for the suggestion, but I did read that plenty of times beforehand, and I don’t see how it could resolve my problem? What am I missing here?
Enginn Heima
February 8, 2019 at 5:48 pm in reply to: Monitor calibration

How do you “force” it to data levels? I did right the click the clip in the media pool, selected clip attributes and turned it from “auto levels” to “data levels”…

And how can I verify if “I’m monitoring output levels correct yo my monitor”?

Thanks for the help!!
Enginn Heima
February 8, 2019 at 4:03 pm in reply to: Monitor calibration

Didn’t do the trick, it was set to Auto, and putting it to video levels didn’t change anything.

On the other hand, when I’m in the media pool and I select the original clip the clip appears as it should on my video monitor, that is, not washed out!!!

When I then go into edit, boom, it appears washed out…. I checked in Color with timeline selected, there is nothing applied to the timeline….
Enginn Heima
February 8, 2019 at 1:34 pm in reply to: Monitor calibration

I set them to No LUT, but the change is ever so slight on the scopes, but I dare say that the output to my video monitor is still the same.
Enginn Heima
February 8, 2019 at 12:51 pm in reply to: Monitor calibration

Thank you for the input. So any suggestions as in which LUT to select here?

Page 3 of 10

← 1 2 3 4 … 10 →