Dwaine Maggart
Forum Replies Created
-
In the Stabilizer window menus (icon in the upper right of the window area) select “Clear Track Data”. Make sure all the checkboxes in the next window are checked (should be by default) then click Clear.
Dwaine Maggart
Blackmagic Design DaVinci Support -
It’s not a Resolve thing, it’s a Mavericks thing. And yes, the new Tangent panel firmware will allow the Wave to work properly with Mavericks.
Dwaine Maggart
Blackmagic Design DaVinci Support -
In the Deliver page Output options, make sure “Enable flat pass” is set to Off. Based on your screen shot, it appears to be, but make sure it really is before you Add Job.
If that’s off, Resolve pretty much has to be rendering what you see on the Deliver page viewer, while it’s rendering. Make sure you are really looking at the rendered files, and not the source files.
Dwaine Maggart
Blackmagic Design DaVinci Support -
No.
Dwaine Maggart
Blackmagic Design DaVinci Support -
So just to confirm for the thread, we’ve tested the GTX285 for Mac and the GT8800 for Mac and the GT120 for Mac. None of these cards are recognized as CUDA cards under Mavericks, so none of these cards can be used as Resolve GPU cards under Mavericks. The GT120 can be used as a GUI card.
We don’t have an FX4800 card here to test, so not sure about that. Be curious if anyone had one they could test.
And also, since this is a Mavericks thread, you must use Resolve 9.1.6 or later, or V10 Beta 3 or later with Mavericks. Earlier versions will not run under Mavericks.
Dwaine Maggart
Blackmagic Design DaVinci Support -
Hi Jef,
Could you provide us with a link to your AAF?
Dwaine Maggart
Blackmagic Design DaVinci Support -
No idea why it would be greyed out. Is anything else in the LUT area greyed out? What version of V10 are you using (DaVinci Resolve / About DaVinci Resolve). Mac or Windows? If you open a new project, is the Scope LUTS stuff greyed out?
Dwaine Maggart
Blackmagic Design DaVinci Support -
No.
Dwaine Maggart
Blackmagic Design DaVinci Support -
Assuming you are using V10 Beta 2, in the Project Settings / Lookup Tables area, there are new selections for 1D and 3D Scopes LUTs. By default, these are set to “use Video Monitor Selection”. If you don’t want a LUT on the WFM, then select “No LUT selected” in the 1D and 3D Scopes LUT sections.
Dwaine Maggart
Blackmagic Design DaVinci Support -
Resolve does not currently support spanned C300 clips.
Dwaine Maggart
Blackmagic Design DaVinci Support