Replies – Forums – Dan Estes

Forum Replies Created

Dan Estes
August 22, 2007 at 5:21 pm in reply to: DVD Architecture

Thanks for the sugestions.
Dan Estes
August 20, 2007 at 1:07 am in reply to: DVD Architecture

I re-installed DVD Architecture 3.0 and burned a DVD. Everything is working well now. There must be some kind of compatability between 4.0 and my burner. Also, I have the most recent firmware for my burner.

Oh well, at least I’m back to making DVD’s.
Dan Estes
August 19, 2007 at 6:28 pm in reply to: DVD Architecture

One more question. After attempting to burn seven DVD’s unsuccessfully, I noticed all DVD’s skipped at the same locations and increments on playback. Would this still indicate the burner being a hardware problem?
I am going to uninstall DVD architecture 4.0 and re-install 3.0 and see if I have the same problem. If this doesn’t work then I will assume the burner is a problem. NOTE: It was okay before I instaled 4.0, but things can happen.
Dan Estes
August 19, 2007 at 10:05 am in reply to: DVD Architecture

You are probably right regarding the age of the burner. I will probably have to replace it and get a new one.

Thanks.
Dan Estes
August 18, 2007 at 9:32 pm in reply to: DVD Architecture

I have the bitrate set to 8.2. Also, I am using the same CD/DVD burner as I did using Vegas 6.0 & DVD Architecture 3.0. The burner does burn cd’s and DVD’s, but I’m having difficulty with burning successfully using the new version of DVD Architecture 4.0.

NOTE: I was able to burn a DVD using DVD Architecture on another computer.

– Still would appreciate some additional sugestions.

Thanks again.