[Coburn Erskine]

Working in fcp 7.0.3, hackintosh, 6 core.

I had this problem as well. Had three angles, two of which were 720X480 and the last at 960X540. Downrez wasn’t working with the 960 so I ended up uprez’ing the 720 shots.

Prores 422, 29.97fps, 32KHz, 32 bit float. All three files had exact same settings. So multicam should work fine right? Nope.

Same problem as above, would begin playback in canvas with both canvas + viewer open sync yet it would only play the master clip in viewer. Tried turning on button bar for multiclip buttons on sequence but that didn’t work either. Grey markers would appear but immediately disappear when I stopped playback. No cuts. Would switch to which ever shot I last chose.

Funny solution I found, turn RT Extreme on and have your multiclip in the timeline unrendered. Should have the Unlimited orange bar above timeline. Frame rate half, video playback half as well.

This worked for me. Could play the multiclip and cut between my three shots as it played back. Not perfect but hopefully this helps.

Coburn