Replies – Forums – Chris Tompkins – Page 199

Forum Replies Created

Page 199 of 283

← 1 … 198 199 200 … 283 →

Chris Tompkins
April 5, 2011 at 6:06 pm in reply to: Audio fine on DVCAMplayback, incredibly low when captured to FCP

If you captured via FW and you had AUDIO selected as well as vid then it should be there. Unless you captured audio tracks 3&4 by mistake?

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 5, 2011 at 4:48 pm in reply to: Batch Capture & Change Clip Settings/P2

Ya, the “Capture Scratch” folder setting stays the same no matter what proj. you open. You have to go into System Settings and change it.

I have projs. allocated to different drives and sometimes I forget to change that. A small pain. Maybe with the next version of FCP we can have multi-Scratch drive settings for various projs.

Glad you got it worked out.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 5, 2011 at 2:45 pm in reply to: Batch Capture & Change Clip Settings/P2

You may have to re-load manually. Maybe assistant should…
I’m not sure if you can alter A/V tracks selected to re-load from Disc media. You should.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 5, 2011 at 1:55 pm in reply to: Cinema Tools oops. I need to revert back to 60P

Cinema Tools will alter the original clip when you conform. You should always make a copy with doing this.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 5, 2011 at 1:49 pm in reply to: Batch Capture & Change Clip Settings/P2

Varible Frame Rate (VFR) Overcranking, etc…
If so, there is NO audio.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 5, 2011 at 11:49 am in reply to: Syncing audio wtihout a clapperborad

ADD More Video Tracks.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 4, 2011 at 6:27 pm in reply to: Syncing audio wtihout a clapperborad

Plural Eyes.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 4, 2011 at 4:44 pm in reply to: Up-ressing 4:3 SD media to HD

Check your distort settings in FCP.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 4, 2011 at 2:34 pm in reply to: Syncing audio wtihout a clapperborad

Turn on audio waveforms and zoom in and sync it visually.

Chris Tompkins
Video Atlanta LLC
Chris Tompkins
April 4, 2011 at 2:33 pm in reply to: How to setup project for mixed fps?

It’s usually best to go with what you have the most of or best matches your end deliverable. Then conform the rest prior to importing. Some stuff you can just drop the mixedmatched clip in and render it to the sequence without issue.

Chris Tompkins
Video Atlanta LLC

Page 199 of 283

← 1 … 198 199 200 … 283 →