Forum Replies Created

  • Cecily Rhett

    November 17, 2008 at 4:24 pm in reply to: 24p sync issues

    I’m just coming onto a project that was captured in the same way – HDCam SR SDI through Mojo and not logged to start on the “0” or “5”. Just curious, when you changed the starts, did the jittering problem go away?

    Also – were the cuts themselves off by a frame or 2? Or by more than a frame?

    Thanks, Cecily

  • Cecily Rhett

    September 12, 2006 at 2:55 pm in reply to: Modifying Emulsion Codes for Film Lists

    Dear Michael,

    Thank you! (They are terrifying messages..)

  • Cecily Rhett

    September 6, 2006 at 5:36 pm in reply to: Newcomer to 24p ntsc, pulldown problem?

    dear moztu,

    i know you are probably done with this issue…but it seems to me that your problem is with the xpress pro you were going directly in via firewire and not going through a device to remove the pulldown for the computer. in my experience, xpress pro has no software-based solution to remove pulldown and get you back to your 24fps. i solved this problem in xpress pro (4.6) by capturing on a full media composer set up with the requisite hardware and then cutting in xpress pro at 24.

    best,

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy