Replies – Forums – Ari Mannis

Forum Replies Created

Ari Mannis
June 26, 2014 at 5:48 pm in reply to: Tascam DR-60 One Input sounds different

Yea,

The problem was ms matrix was on
Ari Mannis
May 21, 2014 at 6:59 pm in reply to: Tascam DR-60 One Input sounds different

Turns out the problem was MS Mode was turned on.
Ari Mannis
May 20, 2014 at 3:06 pm in reply to: Tascam DR-60 One Input sounds different

I was recording a steareo mono mix file…
Ari Mannis
May 20, 2014 at 8:36 am in reply to: Tascam DR-60 One Input sounds different

How do I keep mics on serperate tracks in the dr-60?

Also how would i fix the issue if it is a “phase” problem.
Ari Mannis
May 20, 2014 at 5:39 am in reply to: Tascam DR-60 One Input sounds different

I only recorded one track so I think it only recorded at one volume.
Ari Mannis
May 20, 2014 at 2:38 am in reply to: Tascam DR-60 One Input sounds different

Il write down all the settings I have it on wed… because I haven’t changed anything so I’m sure it Wi happen again and I need to fix it so I don’t get fired.
Ari Mannis
May 20, 2014 at 2:29 am in reply to: Tascam DR-60 One Input sounds different

Two mics plugged in
Ari Mannis
May 20, 2014 at 12:39 am in reply to: Tascam DR-60 One Input sounds different

Im pretty sure im telling everything, there is only one track… with both mics plugged in… im literally plugging two identical mics into the DR-60 and pressing record… I have done zero effects in post production and one the mics sounds tinny…
Ari Mannis
May 19, 2014 at 7:15 pm in reply to: Tascam DR-60 One Input sounds different

It has gone through editing just to show you the two different voices… i have ran no phase thing unless it I a setting on the device that I don’t know about… any thoughts?
Ari Mannis
May 19, 2014 at 4:17 am in reply to: Tascam DR-60 One Input sounds different

What sort of mics?
SM 58

Positioned how far from the people speaking?
They talk right into it.

Did you listen to each microphone as a single mic or were you listening to the mix of both mics?
Mix of both mics.

Did you mix to mono on site or recorded them as separate tracks and then mono’d them in post prod?
On site.

Have you ever tested your mic cable wiring are they correct ie; pin 1 to pin 1, pin 2 to pin 2, and pin 3 to pin 3?
They are three pin xlr cables they are plugged in correctly.

Are they pro made cables or DIY cables?
Pro made and tested.

Also when monitoring the audio it sounded fine.. just in playback on the computer one sounds tinny for some reason.

My gut feeling is it a 180deg phase problem, if you still have the recording as 2 separate tracks phase reverse just one track (either one … ) then try to mono mix it and see if that makes a difference.

I just recorded to one track I believe…. maybe il figure out how to do two from now on… what is phase 180?

Thanks for your help hopefully these answers help you to determine what is wrong.