Antonio Aguirre
Forum Replies Created
-
Yes sir I do, I don’t blame you for asking. Usually things like this are just what we call a “air gap.” Good news is though, however, I finally got it to export the whole program. However, I set my frame size to 960 X 720 and the program came out at 1280 X 720 or something to that effect. I brought it back into FCP and proceeded to cut the show using the Multicam Edit and all was well. Except now I have to Render the whole show because the frame size on the Sequence doesn’t match what I brought in. I’m not sure why it exported to that particular frame size after I chose “Custom Settings” and set specifically to 960 X 720, because I shot it at 720P 24 PN on the HVX-200. Nonetheless, I finally cut it and now I’m on to Post Audio. But if you have any knowledge to shed on why it exported at the bigger frame size, I am grateful. Thank you sir!
Antonio
Antonio
-
I am monitoring the audio as the preview when I capture my footage out of the deck. I am also not going back into the deck from the AJA. It’s never done this before and I have hooked it up the same as always. Thanks for the response and I hope we can figure it out. Also, the fact that my AJA’s firewire status light on the front of the unit is not lighting up. Do you know what could possibly cause this. Thanks again.
-
Sure will.
It does play fully in Quicktime. I’ll check the heads of the deck we recorded on, I know they haven’t been cleaned very recently.
Thank you. -
I’m workin’ on a Final Cut HD. I had no audio and the bars were at the beginning of the video. Someone came in and figured it out. Actually they just dragged the file onto desktop and then dragged it in to Final Cut and all of the 3 hours were there. It was really strange. Any explanation? Thanks.
-
There were timecode breaks in the capture. And the size of the file was 39 GB. Thanks.