[Anthony Sharpe]

Hi Tony,

thanks for the suggestion.
I will give that a go and see if it helps.

cheers,

anthony.

[Anthony Sharpe]

Hi,
I have been searching around trying to find a solution to this problem and stumbled across this posting.
My problem is that no emitters or replicators are showing up at all, not even the final cut pro ones.
My prefereences had set the path file as users/shared
in this location I have a folder called Motion that has the library folder and then all the other expected folders inside this eg: behaviors, replicators, particle emittors, etc…
I always get the behaviours to show up inside the motion library area, but never the paricle emittors or replicators.

I then copied the whole motion folder to library/application/support/final cut studio
folder (so now I have two lots of the same motion folder)
I then pointed the path to the above destination, then did a restart and still no joy.
i then trashed my .plist and this took it back to the users/shared folder (which I left the original copy of Motion library folder) and still no joy.

i am completely stumped.
as per the above posts, I too get the following when I click on particle emitters or replicators in the library inside of motion:
All (0 items).

any hep would be appreciated…

regards,

ant…

[Anthony Sharpe]

thanks,

sorry about posting in the wrong forum.

Out of interest, I figured it ot. The camera was bought in japan and therefore it was an ntsc verses pal issue with the different frame rate. Nothing to do with being an mpeg 4. I will know next time.

cheers,

anthony.