• Maxon Cinema 4D

  XPresso: access clone parameters?

  Posted by Thomas Ernst on September 3, 2010 at 8:57 pm

  Hi all

  I’m pretty sure it’s not possible, but before I bang my head against the wall anymore, the question is:

  I have a cloner cloning a sweep nurbs. I’ve animated the sweep nurbs using end growth and then used a step effector to offset the growth of each clone. I want to attach an object to the head of each sweep nurb. I had done this as a one-off using XPresso and range-mapping the end growth parameter to the position of the object.

  Is there any way in XPresso to access individual parameters of a particular clone?

  thanks
  –tom

  Thomas Ernst replied 15 years, 11 months ago 1 Member · 0 Replies
• 0 Replies

Reply to this Discussion! Login or Sign Up