-
Stailization not showing up in Inspector
Hey Folks,
So I have done the stabilization analysis in a couple pieces of footage and it goes through the analysis fine. However after analyzing I have no section in the inspector for Stabilization. Is there a switch or something I have to throw somewhere?
Thanks
-
2 Replies
-
Are the clips in a project (timeline), clicking on a clip there and then looking at the properties will show the controls.
Olof Ekbergh
-
Figured it out. It was in a multicam clip that was in the timeline. I needed to go to the timeline for the actual multicam clip and apply it there.
Michael W. Towe
President M2 Digital Post
http://www.m2digitalpost.com
Reply to this Discussion! Login or Sign Up