-
SD 633 Boot Loop
Today on set, as I started putting lavs on talent, I noticed I couldn’t hear talent through the headphones. I looked down, saw the meter bouncing but no out. Fiddled with the headphone jack to no avail. So I just flipped the power off and back on again. It started booting, then crashed. Then started booting, then crashed.
Right now all it does is flash channel 1-3 led lights. Steady for a few seconds, then blinks twice, steady for a bit, blinks once, then repeats. Even doing a reset with batteries and without, different batteries of double AAs results in nothing.
Any advice?
-
1 Reply
-
Hi Dani and welcome to the Cow Audio Forum.
Yes. Contact Sound Devices at your earliest convenience.
Here’s a link to their online forum. https://forums.sounddevices.com/forum/field-mixers/-633-mixer?_=1448207906420
Until then, try a hard reset. Turn the power switch off. Hold the menu button for 7 seconds. Then power back up.
Check your media: unapproved media can cause these problems
Also, reformat the media for each project.
Regards,
Ty Ford
Cow Audio Forum LeaderWant better production audio?: Ty Ford’s Audio Bootcamp Field Guide
Ty Ford Blog: Ty Ford’s Blog
Reply to this Discussion! Login or Sign Up