-
Off-setting sweep end growth with use of a cloner
I have a b-spline that is curved from one point to the other and i have a cloner to duplicate the same. what i’m trying to figure out how to do, is to off-set each clone’s end-growth. (i.e. original start to finish 1-30 frames, clone 1 5-35 frame, etc. or is there an easier way?
-
2 Replies
-
nevermind, figured it out. Just hit C on the cloner.
-
You could also do it this way, assuming I understand your basic setup.
Reply to this Discussion! Login or Sign Up