Doh!

[Ed Dooley]

It’s pretty easy since you haven’t captured yet. In the batch capture window there’s a checkbox “Use Logged Clip Settings”. If you de-select that box, and set the log & capture seting to Audio & video, it will Capture based on your new setting, by-passing the logged setting.
Ed

[kevin] “I accidentally logged all my clips to be captured (betacam SP). Captured them and then relized I captured only the video and not the audio as well.
How do I RECAPURE with video and audio? In the batchcapture window I don’t see how/where to change the original capture settings?
Or do I have to start over?
“

[David Rowan]

You can also contl click on the clips in the bin and modify them from there. You do this on the name of the clip, not in the column thats says “V” or “V2A” etc…

DWR

[Gregg]

Can you do this after you have already done the batch capture?

[Ed Dooley]

I’m treading on thin ice here, because my only experience is in wanting to capture audio *after* logging just video,
but *before* capturing*. The way I suggested seems so easy. There may be easier ways, but unless the already
captured video was tweaked during capture and you want to preserve those settings, I would select all the video clips you’ve already captured,
and that you want audio for, and make them off-line (delete them from the drive), recapture, but choose audio *and* video in the clip settings,
and de-select the Use Logged Clip Settings box. It will redigitize the video, and digitize the audio with it. It won’t take any longer than if
you digitize the audio only (it’s going through the same TC).
Ed