Replies – Forums – Walter Ungerer

Forum Replies Created

Walter Ungerer
January 7, 2012 at 8:52 pm in reply to: Routing cable connections from MacPro using Mackie 1202

You answered it all. Thanks, much appreciated.

Walter Ungerer
Walter Ungerer
February 25, 2010 at 9:30 pm in reply to: Optical stabilizer filter problem

(continuing from the previous message) I have installed an additional 4 GB of memory, but I continue to have the problem: “Could not complete your request because a memory allocation failed”. It seems the amount of available memory is not the issue…but what is it? I can apply the optical stabilizer filter and render one composite clip, that’s all before I get the error message. Anyone have suggestions about where to search? My application is just download Media 100 Suite 1.5.

Walter Ungerer
Walter Ungerer
February 19, 2010 at 3:06 pm in reply to: Optical stabilizer filter problem

Boris,
Thanks. I’ve ordered an additional 4GB RAM. When installed, I’ll post the results.

Walter Ungerer
Walter Ungerer
February 17, 2010 at 5:40 pm in reply to: Memory leak or memory allocation?

Wick,
It seems to me Mike’s memory allocation message, though the same message as mine, probably was generated by a different problem. It would be very helpful if the Media 100 program could generate more than a “heads up” about a problem. If a diagram could be generated along with the warning message, leading us to the possible origin of our trouble; then we could do more accurate trouble shooting. Presently the message is too vague, and it’s just a lot of trial and error searching. Often we are left with workarounds, if we are lucky. I think the work of your stressful job would be alleviated, too.

Walter Ungerer
Walter Ungerer
February 15, 2010 at 4:18 pm in reply to: Memory leak or memory allocation?

Wick,
Thanks for the reply.
Vertical Render was never applied, but I tried applying it after your message. Negative. When enabled it brings up the memory allocation message even earlier. Can I render the applied filter clip? Yes, but at this point I can only render one or two clips before the message appears and I have to close M100 and reopen. Because of this problem I have been rendering each clip immediately after applying it, not batch rendering. I still have about 125 clips to which I have to apply the filter. I’m afraid shortly I won’t even be able to render one clip. I wondered whether buying more RAM and adding 2 GB RAM might help.

Walter Ungerer
Walter Ungerer
February 15, 2010 at 2:53 pm in reply to: Memory leak or memory allocation?

Correction: approximately 3000 clips (not 300) with optical stabilizer filter applied over presently 54 minute project.

Walter Ungerer