[Tim Coakley]

Solved! You were right… I thought INT SG was the proper setting because HD SDI lit up when I had it on, and the only other options were DIG and ANA. I didn’t know about the DIN setting on the audio menu (DIN 12, DIN 34, etc). The DIN was set to the factory preset of AES. At this point, audio channels 1-8 didn’t give me the HD SDI option. When I changed the DIN input to SDI, then I was able to see the HD SDI option on channels 1-8 the HD1700 VTR. I then changed those setting to HD SDI and I was good.

Thank you for your time and help!

Tim

[Tim Coakley]

After adjusting some settings on the deck, the video is now stable… but not getting any audio from the AJA to the deck (using HD SDI) … audio settings on deck are at INT SG, which should be the proper setting for audio via the HD SDI. Tested AJA directly to a monitor and the audio is there. Baffled.

Thanks for the responses.

[Tim Coakley]

The display on the deck says playback and record are set for 720p. Even when I disconnect all the cables from the deck and only feed the monitor from the AJA, I’m having the same bad video signal.