Replies – Forums – Thomas Moore

Forum Replies Created

Thomas Moore
March 22, 2010 at 7:12 pm in reply to: Interlaced in interlaced out Sony Vegas 9

Thanks DSE, but you may have mis-read my question. The footate is already 1080/60i and I want to be sure it goes back out 1080/60i and hence my question about de-interlace…
Thomas Moore
November 4, 2009 at 3:17 am in reply to: Best Project and render settings to create DVD?

Thanks again for your help, I see now that it is showing average bit rate… However it is showing (9800) in red see https://img215.imageshack.us/i/bitratet.jpg/ not sure how to interpert this?
Thomas Moore
November 3, 2009 at 2:32 pm in reply to: Best Project and render settings to create DVD?

Thanks, I was looking at that last night, I noticed that the calculator only gives you the max bit rate… What is a good ratio for the average and minimum then?

I also noticed that Ultimate S Pro will render the video for you, does it use CBR or two pass?

Thanks again for the help!
Thomas Moore
November 2, 2009 at 9:11 pm in reply to: Best Project and render settings to create DVD?

Thanks, my intent was to do some slow motion, this was a sporting event so knew that there would be different sections I’d want to slow down.

So following your advice – I should change the project to match the Neoscene files – I know how to do that – then render out using the default MPEG2 DVD Architect NTSC Widescreen video stream with no alterations at either 60i or 24p. Should I use CBR or two pass? Will the ultimate-s-pro-4.1 calculate this for me properly?

Thanks again for your help!
Thomas Moore
November 2, 2009 at 12:55 pm in reply to: 5.1 DVDA issue

Thanks, setting to -31 helped as well.
Thomas Moore
October 16, 2009 at 1:36 pm in reply to: VAAST training DVD’s adding plugins?

Guess I didn’t mention that I’m using 9.0b 64 bit….
Thomas Moore
October 13, 2009 at 12:27 am in reply to: Help with settings

Thanks, I’ve been reviewing and posting on a few other forums and mostly see that I should actually record and stay in progressive. Any reason why the interlace suggestion?
Thomas Moore
September 22, 2009 at 4:05 pm in reply to: FanMade Trailer Please critique

Seems OK, I would get rid of the F&*& word though doesn’t add anything to it just detracts.
Thomas Moore
September 1, 2009 at 3:47 pm in reply to: Project/render settings when mixing 1080 50i & DV WS?

I have a question related to this…

So you always want to use the lesser of resolutions for the project, however what about the clips themselves? Maintain aspect ratio or Source?
Thomas Moore
August 25, 2009 at 11:23 am in reply to: Blue bars how to remove?

I used an older Sony HandyCam I’m surprised it is that bad myself. They turned up the brightness of those lights after I’d set up and my camera person wasn’t very expireinced 🙁

I’m wondering if I can use them to my advantage in some areas; use some light flares or something to hightlight the bride.

What range of blue should I adjust though otherwise to minimize? Low, Mid or High?