[Richard Carroll]

Ah well it turns out you’re all wrong. Dammit!

I spoke to several BMD reps at a trade show in London today and they all said the GPI/Tally does not (currently) accept GPI in.

They said it WILL. But could not say when…

Thanks for your input.

Anyone seen my drawing board?

[Richard Carroll]

Thanks for your response.

I want to use this for camera touchdown/preview, using a Sony RCP 750 which offers contact closure GPI.

I’m hoping I can take the GPI out of the RCP, input it to the BMD Tally GPI box and control crosspoint routing on a BMD video hub.

I cannot find any instructions to make it do this. I’m guessing it’s GPI in via the 25pin and the ethernet is connected to the video hub, either from a panel or from the ethernet router. I am also guessing the TallyGPI is programable for which cross points can be switched, or is it just 1 – 8?

Thanks
Richard

[Richard Carroll]

Hello All,

I’m just wondering if anybody has got a simple method of making this work.

Still no sign of a GPI device from BMD.

I too am after simple over press for cameras

I’ll contact BMD direct too, any useful information I’ll post back here.

Thanks
Richard