[Paul Buhl]

Bob,

thanks again for all the help.
Spoke to Kona today, looks like a bad card, they are overnighting a new one.
Customer support is excellent there.

Paul Buhl

[Paul Buhl]

reloaded the drivers, still no video.

it’s looking more like a bad card.

thanks again.

[Paul Buhl]

ok –
you said that you COULD get the Kona Control panel test patterns on your TV – am I correct ? This means that your Kona card can output to the TV monitor (am I correct ?).

YES

One more time – take the beta analog component output (with 3 cables) into the AJA KL box (your breakout box) inputs. Make sure the INPUT tab of the control panel is ANALOG COMPONENT BETACAM – when you play a beta tape, you should see a picture.

IS AS YOU NOTED, STILL NO VIDEO

If you do not, take the cables that came with the Kona LHe card, and disconnect your KL box, and use the break out cable they gave you. Try the same test, using the cables that come from AJA on that break out cable.
If this does not work, let me know.

TRIED IT, STILL NO VIDEO

If this does not work (with the original AJA Kona breakout cable – NOT using the AJA KL box – you should RELOAD your Kona drivers from the AJA website, and try again. If this still fails (and you are ABSOLUTELY SURE that your BNC video cables are ok), you may have a bad Kona card.

CABLES HAVE BEEN TESTED, ALL ARE GOOD.
I WILL RELOAD THE DRIVERS NEXT, THANKS AGAIN.

[Paul Buhl]

I’m there…
still no video

[Paul Buhl]

Thanks Bob,

Do you think there is a confilct issue with capturing with the DVCPro50 Codec?
I noticed there’s an 8 bit to DV Easy Setup, but that gives me DV25 capture.
I would like to use DV50 bitrate.