Replies – Forums – Olivier Bochenek

Forum Replies Created

Olivier Bochenek
October 31, 2011 at 12:10 pm in reply to: slow fade-in from left to right ?

thanks, the crop tool in final cut works even if i find the edge feather not wide enough for my needs even at 100.
in Motion i don’t find the bahaviour «text-basic, fade character left-in» ? or even the feathered edge mask ? i’m in motion 4, not 5 !
Olivier Bochenek
October 31, 2011 at 4:30 am in reply to: slow fade-in from left to right ?

i already spent many hours trying… that’s why i ask here
Olivier Bochenek
October 31, 2011 at 12:23 am in reply to: slow fade-in from left to right ?

thanks but there is just a on/off feather edges option in final cut, i want to be able to adjust the width very soft… ?
Olivier Bochenek
September 4, 2010 at 1:59 pm in reply to: trying to match P2 and D90 footage… off sync

Hi Michael,
when i drop the converted QT in 24 FPS on top of the 23,98 FPS one, they are the same from start to end, only the frame rate has change. But the clips are still stretched of 2-3 frames compared to the P2 track.

Your 2nd option made good results: I took the Quicktime in compressor and applied the retiming control at 99.93 % and it works, no more désynchro after 2min.

thanks !
Olivier Bochenek
August 7, 2009 at 10:00 pm in reply to: XDCAM log workflow

my answer seem to not be posted !!?!!
thank you for the answer
i’m the editor ans i don’t know where we’re going with all that !!

the realisator is having a double of the medias
He is selecting parts of clips for me with XDCAM transfer, this creates new .MOV with new names… maybe we’re OUT of the good procedure

is it possible for him to
1-select parts of clips
2-make a EDL (how ?) and send it to me
3-i relink his selection and edit

he tried to send me a fcp project but the clip was relates to a new .MOV made on his side

we’re lost !

thank you
Olivier Bochenek
August 7, 2009 at 9:45 pm in reply to: XDCAM log workflow

hi,
i’m the editor.
all of this is too new for us… i don’t get it !!!
the new names clips are generated by XDCAM transfer
but the realisator is at his home so the .MOV created on his side… i don’t have them so maybe what we’re trying to do is impossible.

basically what we want is:

1-the realisator is selecting sections of clips with comments ans give names to clips that are not numbers (log list)
2-send me something (log lost, i don’t know) ?
3-i relink something

maybe he needs to come home with the FCP project created with the XDCAM transfer log ?

thank you
is that possible

thank you and sorry for my poor english