Replies – Forums – Min Shen

Forum Replies Created

Min Shen
March 28, 2009 at 2:57 pm in reply to: Audio saturation who need to be fixed if possible

Dear Randy,

do you mind sharing with us how you did the restoration?

Thanks in advance
Min Shen
February 11, 2009 at 1:29 pm in reply to: Roll off & attentuate on mic capsule or on mixer/recorder?

Hi and Thanks so much to everybody’s reply.

I guess the main reason I would wanna roll off would be for AC and electrical hum. So do you think I should still roll off on the mixer instead?

Besides roll-off, what about attenuation? I understand if it’s extremely loud volumes on location, then it would be best to attenuate straight on the mic to prevent the diaphragm from too much vibration and distortion, so I should definitely attenuate on the mic first, is this correct?
Min Shen
December 22, 2008 at 4:18 pm in reply to: Monitoring 2 units of Linked-up 702T’s

Hi Rodney,
thanks so much for your very clear advice & instructions! I kept getting frustrated at the impedance and stereo issues using direct output from the 702T’s headphones jacks into a single channel on the 302.(using a mini-jack-to-male-XLR into the 302)

I don’t have the gear with me now but I’ll be sure to try it tomorrow. I already have TA3-to-male-XLR cables at hand & the ‘Y’ cables should be easy to solder. It definitely sounds like it should work!

BTW, I think SD were not able to give me a simple workaround because I also forgot to mention I have the TA3-to-male-XLR cables at hand.

Thanks again, Rodney!