[Mike Valladao]

I’m going to come back to this later as I’ve run out of time for the project. I love the idea of doing the 3 objects as it looks much better, but…
I ended up just leaving it a single extruded object and cut the video at 90 degrees, replacing it with an inverted copy so it does one full revolution. It’ll work for now.
Thanks again for all your help Steve.

[Mike Valladao]

Thanks for taking the time to do that- you rock.
I have BCC7 3D Objects, not RED so I can’t open the file within my AE project.
I did adjust the extrusion depth and the z position, but it didnt seem to make any difference. I’ll keep messing with it, though, I’m sure I’m doing one little thing wrong, I’ll get it eventually.
Thanks again!

[Mike Valladao]

Thanks for the suggestion.

I don’t seem to be able to get all 3 spline objects to play well together. The front letters and the middle circle work fine, but I don’t seem to be able to get the rear inverted letters to show up or interact with the other two objects. In addition, when I spin the front two objects around, the front object (the letters) is showing through, so even if I could get the rear object to show up, the front is still bleeding through.

Maybe I’m just going at it all wrong, I’ll keep trying to play with it.
Any further suggestions would be greatly appreciated.