Forum Replies Created

  • Michael Pinho

    November 26, 2013 at 5:03 pm in reply to: Taking XLR from board Then Outputting over SDI to flatscreens

    Thanks Rob, I appreciate your reply.

    I was planning on purchasing an attenuator as a go-between just incase the line level is too hot. I am hoping that will be the only additional tool I will need to handle the signal coming from the board.

    I was under the impression that all SDI signal outs included audio, but i’ll have to comb through the c300 menus to make sure that it is not a stand-alone option.

    Thanks again!

    Mike

    Michael Pinho
    NBCUniversal – Syfy
    Post-Production Coordinator

  • Michael Pinho

    February 19, 2013 at 7:37 pm in reply to: WHAT IS A HARDWARE CONVERSION? 23.98 TIMELINE to 29.97

    Thank you Mark, I see there are multiple instructional threads for the compressor method – for now, I will go that route.

    I would like to investigate the hardware conversion, as I believe my organization is equipped with the necessary equipment we just need to have it correctly set-up.

    Best,

    Mike

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy