[Martin Vanputten]

Thank you Hersh, my email address is mvanputten@oasyshealthcare.com. This is going to help with development a lot, thanks again!

~Marty

[Martin Vanputten]

Apparently the SDK is in c++, however, installing the dll from the batch file blackmagic supplies actually gives reference to c#, even though another post I read said its not implemented yet… but that could be why I haven’t gotten it to work yet.

I’ve asked the same question about commands to send, read a post saying there is, and that they are the same as their other devices such as matrix switches (assuming the commands are ascii), however still doesn’t work.

Essentially we can integrate our own software, I think at this point its figuring out what the commands are that can be sent via ethernet, if the post I read was acurate.

~Marty

[Martin Vanputten]

I’ve done some more digging and apparently you can send commands to the device via ethernet… this would be great if i knew what commands to send, anybody have any insight? Thanks!

~Marty