Forum Replies Created

  • Lee Wise

    October 15, 2008 at 5:51 pm in reply to: best render settings for DVD

    Thanks, Mike! I will certainly give these settings a try. I appreciate the detailed response–and so quickly, too. This is turning out to be one of the best forums I have participated in. Thanks to ALL! And keep up the good work!

    Lee

  • Lee Wise

    October 15, 2008 at 5:20 pm in reply to: best render settings for DVD

    I used the Main Concept MPEG-2, and the DVD Architect NTSC video stream template. Did I miss any option settings?

    Thanks,

    Lee

  • Lee Wise

    October 15, 2008 at 3:28 am in reply to: best render settings for DVD

    Excuse me for jumping in here, but I have been following this thread with interest and I have tried your suggestions, Steve, and DVD Architect 5.0 is giving me a little trouble. I rendered to mpeg-2 a 70 min. video. After importing it into DVD Architect, it tells me that there is not enough room for this video on a 4.7GB DVD. I clicked on the fit to disc button which adjusted the bit rate down to where the video would fit. But then when I try to make DVD, an error message pops up that says it can’t re-compress because the bit rate is set too low.

    Any suggestions?

    Thanks,

    Lee

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy