Ken Nicholson
Forum Replies Created
-
Just take the clip you want to preview, make a lo-rez copy of it (to save disc space), offset (slip) the timecode by 5 seconds, and assign it to a new angle. Make sure you have handles on the media to enable the slip to work.
Ken Nicholson
-
My problem was machine control, but I found out what I was doing wrong. In my Discreet deadit*, when you print to tape, ins and outs come over automatically from the timeline. If you want to change them you can. In FCP, that doesn’t happen, you have to enter the record timecode in the Mastering sub-menu or you get nada. Hence the ‘enter valid in-point’ message. Newbie…
Shoulda asked this on the FCP basics forum.Ken Nicholson
-
What the heck you doing trolling around this place at midnight? Sleeping in the guest bedroom again ?? 😉
Ken Nicholson