[K.brown]

I still had problems:

“you have selected a start point which is a C or D frame this is not supported if you choose to continue the digital cut will act as if it were an A or B frame respectively” clicked continue and then i got,

“exception: ADV Audio DEV: failed to set DIO audio sample rate.”

THEN I decided to cut out the audio altogether to see if I could output video only, “deck failed to cue properly please check edit and pe-roll points”
I tried several diffferent in points, cue the deck locally, etc etc. it would always rewind to far and stop. Also please note i could only select “crash” was unable to select insert or assemble edit.

Just curious but would not having a MOJO in this setup affect this? I was told i don’t really need one.
and should i have the deck/cam input to the front of the CPU as opposed to both cam and drives going in on the 2 FW400/FW800 ports on the back?

At my wits end, I appreciate any suggestions.
thanks,
K. Brown

[K.brown]

I shot it on minidv on a panasonic dvx100b at “24p ntsc”. I haven’t tried a hub as previously suggested because that didn’t really quite make sense. However the capturing although not very cooperative did work, it’s the outputting thats the current problem. I will try reimporting the cd at 44.1 instead of converting it on import to 48. just a habit. and remarry it to a duplicate sequence and see if that changes anything, will let you know, i am constantly doing that at work on adrenaline with no output problems, so we’ll see.
Thaks so much,
KBrown.

[K.brown]

Thanks for the info, I wonder what people used before FW 800?
I will try a hub.
thanks,
KB