Replies – Forums – Karen Kent

Forum Replies Created

Page 1 of 2

1 2 →

Karen Kent
March 20, 2009 at 1:08 pm in reply to: Scrambling from 1 word to another

Thanks Filip – that’s pointing me in the right direction!
Karen Kent
March 19, 2009 at 7:50 pm in reply to: Scrambling from 1 word to another

The keyframes, however, are toggle hold keyframes (&, apparently, can’t be changed)…not exactly what I’m looking for, but I’ll make it work. Thanks everyone!
Karen Kent
March 18, 2009 at 9:28 pm in reply to: Scrambling from 1 word to another

OK. Thanks.
Karen Kent
March 18, 2009 at 9:03 pm in reply to: Scrambling from 1 word to another

I have been trying that, but I can’t seem to change the 1st “word” it uses to the word I want. It does just what I want, except for that.
Karen Kent
March 18, 2009 at 1:14 pm in reply to: Scrambling from 1 word to another

I did that & already browsed the presets & didn’t see what I need. I’m on CS3, BTW. Thanks!
Karen Kent
October 19, 2007 at 2:54 pm in reply to: Freaky resizing issue

There is no camera in the comp, but since the layers themselves are rotating in 3D space, he doesn’t need one, right? I will have him check the view, though. Thanks!
Karen Kent
November 2, 2005 at 9:43 pm in reply to: burning timecode

Thanks for the suggestions, guys. I had thought about doing it in AE, but my timeline is over an hour (1:06, to be precise), & that would make for some heavy render time. I guess I’ll try the Boris route, but I’ll still get a big render hit there, too. Alas…
Karen Kent
October 24, 2005 at 6:36 pm in reply to: Problems digitizing

I have all energy saving system prefs off. Also, I sawpped cables & channels for on the SCSI drive with no luck.
Karen Kent
October 21, 2005 at 8:22 pm in reply to: Problems digitizing

Digitizing on the system drive yields better results, but the problem still persists. I talked to Atto about my SCSI card & my drivers & firmware are all up to date (I need to update my Express Stripe app, & I will, but that’s most likely not the problem). I’ll swap cables, swap channels on my SCSI card (I’m only using 1) & see if that works. I don’t wanna go back to 10.3.9 (I really like Tiger!), but I will if I must.

Thanks you guys!
Karen Kent
October 21, 2005 at 7:24 pm in reply to: Problems digitizing

Sorry – shoulda said that I tried that already. Also checked that cables & cards were firmly seated.

Page 1 of 2

1 2 →