Replies – Forums – Jim Bunkelman

Forum Replies Created

Jim Bunkelman
August 11, 2006 at 5:51 pm in reply to: 6 channel Audio output to DVCProHD

Got it. Thank you.
Jim Bunkelman
August 11, 2006 at 5:26 pm in reply to: 6 channel Audio output to DVCProHD

Thank you.
It says “Audio Device Control mapping (Ch1-8) 4 Channels. It’s SDI audio so there are 2 channels per channel (so to speak) It should be working. When I try assemble, I get all 5 tracks, but it’s resetting my timecode. This is the first time I have used this setup and Edit To Tape. I appreciate your fast response.
Jim Bunkelman
August 11, 2006 at 5:07 pm in reply to: 6 channel Audio output to DVCProHD

Not sure what you mean by mapping audio channels in device control presets. My audio outputs all have 6 channels. The device control preset I am using is AJA Kona 1080i29.97 Sony VTR A. That is set by the easy Setup.
Jim Bunkelman
December 20, 2005 at 10:17 pm in reply to: Blocky graphics from AE

That doesn’t seem to be the problem. They were rendered premultiplied. I just tried every combination including rendering a file straight, and the edges are still blocky. When I open the file in the viewer, it looks fine. It is only when I import it into my timeline that it looks bad in the canvas window. If I double click on it in the timeline and open the graphic in the Viewer window that way, it also looks blocky. It almost looks like the resolution goes way down, but my sequence settings are the same as the QT movie.
Jim Bunkelman
November 8, 2005 at 7:14 pm in reply to: Light Guide in Set-up Window

I forgot to include….. ATI Radeon 9600XT OpenGL Engine Version 1.5 ATI 1.4.16
Jim Bunkelman
November 8, 2005 at 6:21 pm in reply to: Light Guide in Set-up Window

I have a 15″ Powerbook 1.67 gig with ATI Mobility Radeon 9700. I’m working on a project that is 1792 by 432 pixels with 9 layers of Invig. While working with Invig, AE has been crashing. I was trying various things based on the forum. One of those was turning off OpenGL. I will turn it back on and continue to see if I still have problems with crashing. This is the first time I’ve had any problem with crashing. I just upgraded to Tiger 10.4.3 and InvigPro 4.0.6. Thanks.